A .PCG file is composed of many levels, actually like folders and files
nested inside each other. You can drop down level by level, and load
single banks of Programs and Combis, or even single Programs and
Combis one-by-one.
Let’s use an example where we load Program Bank B from disk, and
place it into Bank C. The following example also applies to loading
banks of Combis; just substitute “Combi” for “Program.”
· (1.1-1) (Disk Mode) -> tab[Load]. Cursor to the desired .PCG file
containing the Combi or Program bank you want to load.
· Press the [F6] “Open” key to go down into the file one level. You will
now see the individual “folders” of Programs, Combis, Drum Kits, and
Global Settings. (Note: not all of these may be present, depending on
how the file was saved.)
· Cursor down so that the Programs folder is highlighted. Press the [F6]
“Open” key to go down one more level. You will now see the individual
banks of Programs (which may be different depending on what was
saved into the file).
· Cursor to the bank of Programs that you wish to load, i.e. “(Prg) Bank
B”. Press the [F8] button “Utility” which comes up displaying “Load
Selected.” Press [F8] “OK”.
· You will now get a dialog asking you to select the destination bank
location. Using the Value Up/Down buttons or the Rotary Data
Wheel, select “Bank C.”
· Press [F8] to complete the load, or [F7] to Cancel.
To go back up the other direction through the levels, use the [F5] “Up”
key.
+ Parameter Guide, Pages 149-153.