If you want to link your sequence with the correct sounds, you will need to create a Volume that contains the Performance that you used. This is done in the Edit Performance mode. Use the following steps to create a Volume:


1. Press PERFORM to access the Perform Menu display.
2. Use the CURSOR buttons to highlight "Edit Performance" and press S1.
3. Press F1 to access the "Performance Common" screen (if necessary).
4. Use the CURSOR buttons to highlight the Performance you used to create your RPS sequence.

NOTE: If the Performance that you used is not shown in the display, use the CURSOR buttons to highlight a Performance name or "-empty-" and use the VALUE dial to select the correct Performance.

5. Use the CURSOR buttons to highlight the NAME box to the right of Volume and press S1 to access the "ASCII Keyboard" display.
6. Use the CURSOR buttons and VALUE dial to select the desired characters.
7. When you are finished naming the Volume, use the CURSOR buttons to highlight [CR] and press S1 to return to the Edit Performance screen. The new volume name will be displayed.