In addition to floppy disks, all of the Sample and RPS song data you create on the DJ-70mkII can be saved to an external SCSI device such as a fixed hard drive, removable hard drive, or magneto optical drive. Use the following procedure to save a Patch to an external SCSI device:

1. Press DISK.
2. Press F4 to access the "Disk Save" display.
3. Use the CURSOR buttons to highlight "Current Drive" and press S1.
4. Use the CURSOR buttons to highlight the desired SCSI device and press S1.
5. Use the CURSOR buttons to highlight "Target" and the VALUE dial to select "Patch."
6. Use the CURSOR buttons to highlight the desired Patch and press S1. "Are You Ready?" will be displayed. Press S1 and the DJ-70mkII will start saving your sequence to the external drive.
NOTE: When saving a Volume, if the drive you are saving to contains Sample, Partial, Patch, or Performance data with the same name as the data you are trying to save, "Same Name Found" will be displayed. At this point you can choose to replace the existing data with the current data (YES), add any new data to the existing data (NO), or exit the screen and rename the current data (CANCEL). The "Auto Rename" function will help to avoid this situation. If "Auto Rename" is turned on, the DJ-70mkII automatically assigns a different name to the Volume you save. For example, if you saved a Volume called "XXX.GUITARS" to an external drive, the DJ-70mkII would save all of the Performance, Patch, Partial, and Sample data associated with that Volume. Then, if you change some of the Patch data and save the Volume again, the DJ-70mkII would save that Volume as "001.GUITARS." Additional Volumes would be saved as "002.GUITARS," "003.GUITARS," etc.