Before you begin sequencing with the JV-1080, it is important to have the audio cables connected properly. Use the following procedure to setup the JV-1080 with a mixer:


1. Turn off the power on the JV-1080.

2. Connect two 1/4" audio cables from the Mix Out L & R jacks on the back panel of the JV-1080 to channels 1 and 2 respectively on your mixer.

3. Pan channel 1 on your mixer all the way left and channel 2 all the way right to get the full stereo image. When you are using a mono signal connect the L (Mono) Mix Out to your mixer and pan the input channel on your mixer to the CENTER (12 o'clock) position. In addition to the Mix Outs, the JV-1080 has two additional stereo outputs that can be used for individual signal routing.