You can delete an Internal-Voice program, KB3 program, setup, or effect by entering the Save
dialog for the Program, Setup, KB3, or Effects Editor.
When you enter the Save dialog, youÕll see a prompt asking you whether you want to save or
replace an object (the object type depends on which editor youÕre in). The prompt for dumping
the object is at another location in the dialog, as youÕll see.
1. Enter the Save dialog by pressing Store. Depending on the editor youÕre in, youÕll see
either a prompt to replace the current effect, or to save or replace the current program
(voice) or setup.
2. Press > repeatedly until you see a prompt asking you to delete the object.
3. Press Yes. The display will show another prompt asking you if youÕre sure.
4. Press Yes again. The display will show Deleted! brießy, then return to the performance
mode you were in before entering the editor. YouÕll also see --Not|Found-- in the
display, indicating that the object is gone.
At any of these prompts, you can press No to cancel the operation.