1) Press PERFORM and turn the DIAL to select PR-A 12 Pop Set 1
2) Turn on EDIT and Press F1 (Common)
3) Cursor Down Twice to Key Mode. Select Layer
4) Press PALETTE
5) Cursor to KEY RANGE UPPER to select the upper range for the parts
6) Cursor down to KEY RANGE LOWER to select the lower range for the Parts
7) turn off EDIT, then press TX and RX together
8) Press desired Part Buttons (under display) to turn on the parts for the split
9) press EDIT, then PART and select a bank and patch for each Part of the Split