By default, the Stage Piano produces stereo audio signals. In cases requiring a mono
signal, use the following procedure to change the outputs to mono:
1. Make sure you are starting from Internal Voices Play mode. This is the default
right after power on. Only the Internal Voices LED and one of the sound LEDs
will be on.
2. Press the Play/Edit button once.
3. Press the Col Select (Column Select) button twice. Both of the parameter-
column LEDs should be off after doing so. (See The Parameter
Display on page 2-12 if you don't know what we mean by parameter-column
LEDs)
4. The top parameter-row LED should be blinking and the display should show
ss s stt t tee e e (stereo) or mm m moo o onn n n (mono). If not, press Row Select repeatedly until this
is achieved.
5. To change the selection, press the Up arrow button or the Down arrow button.
6. If you would like for this change to be remembered next time power is turned
on, press the Store button twice. Otherwise it will revert to the previous setting
next time power is turned on.
7. Press Play/Edit to return to Play mode.
The above sequence may seem complicated, but after reading Chapter 3 it will seem
quite simple and logical. When in mono mode, the left and right jacks produce the
same signal.