Connecting an Rbus device with the DIFAT to ADAT as the Master Device

The DIF-AT can link an RMDB2 compatible device (such as the VM-3100Pro or the VM-7100/7200 Mixer Processors with the optional VM-24E Expansion Board
installed) and an ADAT deck. The DIF-AT provides the interface necessary so that an ADAT can control an RMDB2 equipped device. Use the following procedures for connecting the DIF-AT to an ADAT deck and to RMDB2 compatible devices:

1) Connect the Optical In of the ADAT to the Optical Out of the DIF-AT.
2) Connect the Optical Out of the ADAT to the Optical In of the DIF-AT.
3) Connect the Sync Out of the ADAT to the ADAT Sync of the DIF-AT.
4) Connect the RMBD2 from the DIF-AT to the RMBD2 connection of the VM-3100Pro
or the
VM-7100/7200 Mixer Processor.

NOTE: To connect the RMBD2 connectors, you must use the provided RMBD2 cable,
or cables which comply with the RMDB2 standard. Connecting with other cables,
such as SCSI connection cables, may damage the devices you are trying to
connect to.

Other Popular Articles:
• Connections for Controlling an ADAT from an RMDB2 Device
• Connections for Controlling a Tascam DA series device from an RMDB2 Device
• Why is the input signal of my Aardvark Direct Pro Q10 or 2496 distorted when I run the line level signal into the XLR inputs?
• When my Bomb Factory plugins get initialized i get "Error -50", "OTClientUtilLib could not be found" and other failure messages.
• I am experiencing odd behavior with knobs, presets, and clippings with Audio Desk and Digital Performer.