 |
 |
 |
|
Q:
No audio playback (or poor audio quality, noise) from outputs 5 through 8 on an 888 I/O.
A:
- Verify that the Mode switch on the back of the 888 is set to 8 CH Mode (button should be in).- Verify the 50-pin cable is connected to the Computer 1 port on the 888 (some older 888's have a Computer 2 port).- Check the ends of the 50-pin cable for bent or broken pins.
Other Popular Articles:
• No card available or "You need a Digi DSP card" when launching Sound Designer II with Logic Audio already open. • "No response from ADAT" error appears when choosing ADAT I/O in the peripherals menu • No volume knob is displayed on a track. • Noise burst or click when attempting a S/PDIF digital transfer from Audiomedia II to a Tascam DA30. (DA-30, AMII, AMIII, 882|20 compatibility.) • Noise from Audio Interface outputs where no regions exist. Not region, voice, or track specific. |
Copyright © 2026. All rights reserved.