There is no Sync Mode pop-up in the Hardware setup window

There is no Sync Mode pop-up in the Hardware setup window.

This was reported in a PTIII system with a Bridge I/O. It was caused by the cards order being incorrect. The I/O card in the lowest alpha-numeric slot is considered the clock master. With the Bridge I/O in the lowest slot, the 888 on the Disk I/O was a Slave and could not be switched to Digital Sync, therefore, no Sync pop-up. Once the Disk I/O was moved to a lower slot than the Bridge I/O, the system operated normally.

Other Popular Articles:
• "There were problems while writing the lead-in or lead-out. The disc may be OK." error in MasterList CD.
• "This disc failed the Optimal Power Calibration" error in MasterList CD.
• "This disc is not usable" error in MasterList CD.
• "This drive doesn't support the use of SCMS" error when writing a disk with MasterList CD.
• Tracks (or files) on an audio CD are not recognized by Session Software.