"Error receiving clock from TDM bus or peripheral" in Digitest

"Error receiving clock from TDM bus or peripheral" in Digitest.

- Power cycle the system.- Verify that the card order is correct (Disk I/O, Farm, SCII).- Check if the peripheral cable is connected to the Disk I/O.- Check that the TDM ribbon cable is connected/seated properly.- Remove the DigiSetup file from the System Folder and restart. (DigiTest is relying on the DigiSystem INIT to setup the TDM master bit.)- Interface cable plugged in upside down on d24, Disk I/O, or DSP Farm card.- One user reported that switching his 888 back to Internal Sync (he was using a MicroLynx) fixed this.

Other Popular Articles:
• Pro Tools crashes on launch.
• DAE error -9003 when launching Pro Tools.
• "Could not open 'untitled. image' because it is not the right kind of file" message comes up when trying to open an Image File in MasterList CD.
• Can't instantiate 2 Mod Delays (short, slap or medium) on 1 DSP chip on a DSP Farm.
• An Audio Track will not play. There is activity on the meters within Pro Tools, but not on the Audio Interface.