 |
 |
 |
|
Q:
Pro Control on NT is not recognized.Pro Tools ver 5.0.1
A:
With Pro Tools installation all the required files are installedFollow the directions below to make Pro Control work with Pro Tools.install the diginet driver as follows:* goto the network control panel protocols tab>Add>Have Disk. * type the full pathname for the ProControl directory e.g. C:\Program Files\Digidesign\DAE\Controllers\ProControl and it should find NDIS 3.0 packet driver v3.5. * Select OK, close and restart.
Other Popular Articles:
• MP3 export option does not show upin Pro Tools 5.0 NT Bounce to Disk after installation. • Launching a Pro Tools LE Session that was transferred from a TDM session via Ethernet prompts error:"Session contains a voice/drive mismatch. A track cannot playback an audio file if the tracks voice uses a different Disk I/O other than the audio voice. " • "Unable to start writing disk. code A5" while burning a CD. • What are some causes for hard drive noise in audio files? • Can I use Pro Control and Motor Mix at the same time? |
Copyright © 2026. All rights reserved.