Pro Audio Support

Q:
when I power on reset the ProControl main, 'RESET' is displayed in the channel/group display. On subsequent power on (without power on reset) the RESET is still displayed. After a while it will disappear after powering on.
 
A:
When "RESET" is displayed at start-up, it indicates that the unit has detected a new version of firmware and is resetting the ProControl prefs stored in non-volatile RAM (FLASH memory). This is the same as RESET from the front panel.After you make a preference change, this will no longer appear at start-up.



Other Popular Articles:
• Release date for SampleCell II Plus.
• How do I make a bootable CD for my Mac using Toast?
• How do you put the Motor Mix into Pro Tools Mode?
• "Could not allocate space" when recording online at a time code address past about 12 hours from the session start time.
• -6042 errors on a G4/533 Dual processor.