 |
 |
 |
|
Q:
The default sample rate in Stand Alone mode is 44.1 kHz, how can I change that?
A:
The factory default sample rate of the 888/24 is 44.1kHz. You can change this default sample rate to 48 kHz by moving an internal jumper on the circuit board. This requires careful removal of the 888/24's top cover and physically moving the jumper corresponding to the desired sample rate.Please refer to the 888/24 I/O Installation Guide for specific instructions and guidance.
Other Popular Articles:
• How do I enable/disable DAC muting when using Stand Alone mode? • Why are the inputs on my 888/24 distorting when connected to my Mix Farm card, but operate correctly when connected to another audio card? • I set the Infinite Peak Hold preference in Pro Tools, but the meters on my 888/24 haven't changed, why? • Why am I getting clicks and pops when recording a digital input? • When or why should I calibrate my 888/24's inputs and outputs? |
Copyright © 2026. All rights reserved.