DB25-XLR M+F AES/EBU Snake-DB25 to 4 XLR Male and 4 XLR Female. - Below 192 KHz, AES/EBU carries 2 channels per line, so this snake transmits 8 out and 8 in via the 8 XLR connectors. - At 192kHz sample rate, the 192 I/O is using dual wire transmission. This means the AES snake transmits 4 out and 4 in at 192 kHz. In this case, the connector labeled "output 1&2" is output 1, "output 3&4" is output 2, and so forth.- The 4 XLRF wire jackets are yellow; the 4 XLRM jackets are black, all with appropriate labeling.. - Product MH080; Length: 12 feet.DB25-XLRM Snake- DB25 to 8 XLR Male; Output snake.- Analog or digital.- Red jackets on both ends with appropriate labeling.- Product MH081; Length: 12 feet.DB25-XLRF Snake- DB25 to 8 XLR Female; Input snake.- Analog or digital.- Blue jackets on both ends with appropriate labeling.- Product MH082; Length: 12 feet. DB25-TRS Snake- DB25 to 8 balanced TRS connectors for audio input or output- Analog or digital.- Orange jackets on both ends with appropriate labeling.- Product MH083; Length: 12 feet. DB25-DB25 Snake- DB25 to DB25, standard wiring.- White (12 foot) or green (25 foot) jackets on both ends.- Typically used for communication between any two standard - - - DB25-equipped devices; For example, PRE out to 192 I/O analog in.- Cannot be used for AES/EBU or TDIF digital dubbing. For TDIF dubbing, use the TDIF DigiSnake (below). For AES/EBU digital dubbing, use two AES/EBU DigiSnakes, connected end to end (XLR to XLR). - Product MH084; Length: 12 feet. Product MH085; Length: 25 feet.DB25-DB25R ProControl Snake- DB25 to pin-reversed DB25.- This DigiSnake was developed specifically to compensate for the reversed pin outs on the ProControl. Typically used to connect the 192 I/O output to the audio input of the ProControl.- Purple jackets on both ends with appropriate labeling.- Product MH086; Length: 25 feet. DB25-TS +4 dBu/-10 dBV Padded DigiSnake- Balanced +4 dBu DB25 to unbalanced -10 dBV TS snake.- This snake contains the appropriate padding circuit to reduce the 192 I/O's +4 dBu output signal down to -10 dBV.- For +4 dBu output only. Use any other input snake for return/input.- Grey jackets on both ends with appropriate labeling. - Product MH087; Length: 12 feet. DB25-DB25 TDIF Only DigiSnake- TDIF Digital (dubbing) cable. Designed for digital TDIF transfers only.- Can only be used for TDIF to TDIF- i.e., Tascam MDM to 192 I/O TDIF connector.- Cannot be used for AES/EBU digital dubbing. For AES/EBU digital dubbing, use two AES/EBU DigiSnakes, connected end to end (XLR to XLR). - Brown jackets on both ends with appropriate labeling..- Product MH095; Length: 12 feet.