How to enable DMA:1-Select the Windows "Start" button -> "Settings" -> "Control Panel"2-In the Control Panel folder double-click the "System" control panel.3-Select the "Device Manager" tab 4. 4-Under the "Disk drives" branch, select the IDE drive(s) you are using.5-Click on "Properties"6-On the "Settings" Tab of the disk's properties dialog, make sure the "DMA" option is enabled.7-Click "OK"8-Close the "System" control panel and the Control Panel folder by clicking on the "Close" button9-Windows will prompt you to restart your computer.10-Repeat for all drives present in your computerOnce you have restarted follow steps 1-5 above once again to make sure "DMA" is in fact still set to enabled. If your computer is unable to keep this setting please contact your PC manufacturer.If you do not see an option to enable DMA: -Not having an option to enable DMA on your drives can be problematic for PT LE and cause -9129/-9093/-9094 errors. Installing the generic IDE driver included with Win98/ME usually resolves these errors:How to install the Generic IDE Controller from the Win98/ME CD-ROM:-Insert the Win98/ME CD-ROM-Open the Control Panels>System>Device Manger tab-Expand the Hard disk controllers list-Highlight the IDE Controller device, click Properties-Click the Driver tab and then the Update Driver button-In the Update Device Driver Wizard, enable Search for a better driver... and click Next-Enable the CD-ROM and click Next-Enable Install one of the other drivers and click View List**You know you have been successful when you open the Control Panels>System>Device Manager>Disk Drives list and your drive label reads Generic IDE Disk