Will the 192 i/o put out a +24dbu signal?

Yes, +21dBu is the level at which the distortion is measured. AES-17 (the defining standard for audio measurements) specifies that THD be measured at -1dBFS. Since the box is factory calibrated at 0dBFS = +22dBu (18 dB headroom over +4 dBu, just like the 888|24), the THD measurement level is +21 dBu.The actual min/max levels are:"+4" Input Connector:adjustable from +17 dBu to +27 dBu, factory setting = +22 dBu"-10" Input Connector:adjustable from +3 dBV to +13 dBV, factory setting = +8 dBVOutput Connector:adjustable from +19 dBu to +29 dBu, factory setting = +22 dBu

Other Popular Articles:
• If I use an Apogee converter JUST as my master clock source and distribute it enslaving several 192k HD interfaces will the interfaces sync to the Apogee (my master) clock or will it still be altered because of the PLL.
• On the IK Multimedia installer CD for the Digi 002, Amplitube is labelled on the physical CD and the installer as" Amplitube", not Amplitube SE.
• -9060 error when recording to a FireWire drive. What extensions should I disable that were installed with my formatting utility for my FireWire drive?
• Why does my new "Mirrored Drive Door" G4 not boot, or freeze on the DigiSystem INIT with my Digi 001 installed?
• With Digidesign MachineControl enabled and in "machine chases insert/selection" mode, hitting rewind then stop results in a selection being made on the timeline.