PCR-30/PCR-50: When I use pitch bend lever, it won't reset to zero pitch...

PCR-30/PCR-50: When I use pitch bend lever, it won't reset to zero pitch. Why?

Here is how you re-calibrate the pitch bend and modulation:

Be very careful to follow these directions precisely.

1. Power On while pressing "L1" and "L3".

2. Press "B4".

3. Turn the bender lever to the left slowly and go back to the
center slowly, then press "B1".

4. Turn the bender lever to the right slowly and go back to the
center slowly, then press "B2".

5. Push the modulation lever to the end slowly and go back to the
center slowly, then press "B3".

6. Verify the new bend range and modulation:
When full left, display should indicate 00.
When centered, display should indicate 40.
When full right, display should indicate 7F.
Push the modulation to the end, display should indicate 7F.

7. Press "Enter" and Power Off.

8. Again Power On and make sure that the DataOut LED turns on when
moving the bender and the modulation.

Other Popular Articles:
• I have a UA-20 and the MIDI will not work. Audio is fine, and I can select the MIDI device in the Control Pannel, but when I try to use it I just get nothing. I have been through the Read Me stuff on the CD but it still won't work.
• My UA-20's audio drivers work fine in both standard and advanced mode, but the MIDI port is not working. I followed the guidelines to install the drivers but it fails. When inserting the UA-20 Windows will choose its own WDM driver and the install wizard never comes up. I have tried to uninstall the driver but the same scenario happens, Windows' own driver is chosen automatically. The manual says that if I have this problem I should contact EDIROL.
• I lose my track id numbers when passing digital audio through the PCM90.
• The right output louder than the left from my PCM90.
• How do you overwrite a register on the PCM90?