Pro Audio Support

Q:
When booting my Creation Station, I got a message that says "Overclocking failed." What does this mean?
 
A:
This message indicates that the BIOS in your Creation Station has been reset. This can happen for a variety of reasons, such as power surges or outages, temporary disconnection of the battery, a hardware change, or for no apparent reason at all.

To restore the Creation Station's BIOS to its factory state, please see the following articles:

* CSTowerLE and CSTowerPlus: Article # 31104
* CSRackXT, CSRackPro, CSRackPlus: Article # 31105
* CSRackDual30 and CSRackDual34 shipped after 11/13/06: Article # 31106
* CSRackDual28 and CSRackDual32, and CSRackDual30 and CSRackDual34 shipped before 11/13/06: Article # 31107
* CSDualTower, CSRackDual26, CSTower and CSRack (2007 versions): Article # 31109

If you Creation Station model is not listed here, please call Tech Support for instructions. These models will be:
* CSPro
* CSCube
* CSRack (2006 and earlier)
* CSTower (2005 and earlier)



Other Popular Articles:
• What are the BIOS changes for my CSDualTower/CSRackDual26/CSRack (2007)/CSTowerPL?
• How do I enable the on-board audio card in my Creation Station?
• On my Creation Station, my Digidesign interface works great with Pro Tools, but audio is stuttering or is non-existent in other programs.
• Digital Performer won't accept my Keycode.
• DAE error -9131 immediately on playback of a session in ProTools LE 7.1