Here's how you can restore ToneLab LE's
programs and all its other settings to the
state in which it was shipped from the
factory.
NOTE: Executing this procedure will erase all the programs
you created and saved in ToneLab LE,
and will load the factory-set programs. MIDI
settings will also be initialized. If there are any
settings you want to keep, you should first use
the data dump function to back them up, or use
the “Program sheet” (the fold-out inside the
back cover of this manual) to write down your
settings.
1. While holding down the three buttons ▲, ▼
(4.2), and EXIT/TUNE button , press
the STANDBY switch to turn on the power.
The bank display (3.4) “P” and the LED 1–4
buttons (5.2) will blink, and the name display
(3.1) will ask “RELOAD?” Release the three
buttons you were holding down.
2. If at this point you decide that you really
don’t want to execute this operation, you
can press the EXIT/TUNE button.
3. Press the WRITE button (4.7). The name
display (3.1) will show “LOADING,” and the
factory-set data will begin being reloaded.
When reloading has been completed, the
name display will indicate “COMPLETE,”
and ToneLab LE will automatically switch to
Program Select Mode.
NOTE: Never turn off the power while this reload operation
is occurring.