 |
 |
 |
|
Q:
How do I change the operating level of the 888/24 from +4 to -10?
A:
The 888/24 I/O is factory set to +4 dBu operating levels for input and output. You can individually switch any of the analog inputs or outputs to either a +4 dBu or –10 dBu operating level by moving internal jumpers on its circuit board.
This requires careful removal of the 888/24’s top cover physically moving the jumpers corresponding to each input and output. Please refer to the 888/24 I/O Installation Guide for specific instructions and guidance.
Other Popular Articles:
• How can I use the 888/24 in Stand Alone mode & How can I tell if it is in Stand Alone mode? • Q. How can I increase the polyphony of Unity DS-1 and/or Retro AS-1? • Q. What are the recommended Control Panel and memory settings for Unity DS-1? • Authoization tips for Mac users with Retro/Unity Version 2.0.0 CD-ROM or higher (also Retro AS-1 v.2.0.1 or higher): • DMA is not available on my hard drives, and digi001 Pro Tools won't work. I have Intel Ultra ATA drivers, how can I change them? |
Copyright © 2026. All rights reserved.