 |
 |
 |
|
Q:
When using my wireless microphone system I hear increased noise or noise tails. What may cause these artifacts?
A:
Check the setting of the sensitivity control on the transmitter. If it is set too low, the audio input will not be driven properly and the signal-to-noise ratio will be too low.
NOTE: Set the sensitivity control on the transmitter to a position where the PEAK LED will flash occasionally.
Other Popular Articles:
• The receiver of my wireless microphone system sometimes fails to mute when the transmitter is off and I hear lots of noise. What may cause the noise? • There are so many wireless channels available. Why can I use so few of them on stage? • What is the advantage of a radio mic over a hardwire one? • Can I use a wireless system to mic up an accordion? • Why does my WMS 60 microphone system sound louder or softer than another WMS 60 system set to the same gain and volume level? |
Copyright © 2026. All rights reserved.