Load or create a Performance that has several Patches assigned to separate keys on the keyboard (see "Creating a Performance" and "Setting the Split Range in a Performance" on pages 2-3). The Performance contained on the DJ-70/DJ-70MKII Demo disk is a good example of this type of setup. Use the following procedure to create an RPS sequence:


1. Press the RPS button to access the RPS Sequencer page. Play the keyboard to hear the Patches contained in your Performance.
2. Use the CURSOR buttons to highlight "Rec KeyOn" and use the VALUE dial to select "ON" (if it is not already selected).
3. Press the DOWN CURSOR button so that an arrow is displayed under "REC" for track 1.
4. Press REC (under SEQUENCER) so it is lit. The sequencer will start recording as soon as you play the keyboard, press the pads, or move the scratch wheel. There will be a dot next the cursor arrow indicating that you are recording. Press START/STOP (under SEQUENCER) when you are finished.
5. Press the START/STOP button again to hear the RPS sequence that you just recorded.
6. To record the next track, use the CURSOR buttons to highlight "Rec KeyOn" and use the VALUE dial to select "ON" (if it is not already selected). Press the DOWN CURSOR button so the arrow next to track 1 will move to track 2. Repeat steps 4 and 5 to record track 2.
7. Repeat these steps to record additional tracks (up to eight) as desired.