Now that we have a Performance setup the way we want, let's name it and save it to a User location. Use the following procedure to give your Performance a name:


1. Press PARAMETER, so it is lit, then press the COMMON (1/9) button. Make sure that the PALETTE button is not lit.




2. Use the UP CURSOR button to select the "PERFORM NAME" screen.
3. Use the CURSOR buttons to select the character you wish to change and the VALUE knob to select the desired letter.
4. Press UTILITY.
5. Use the CURSOR buttons to select "WRITE" (it should start to flash).
6. Press ENTER. The destination of your custom Performance (USR: 12 Orchestral) will be displayed.

NOTE: The default destination will always be the User equivalent location of the Preset you started from. Since we started with Preset A:12, the default destination is U:12. If you want to select a different destination, simply turn the VALUE dial to select another User Performance.

7. When you have selected the desired destination Performance, press ENTER.

NOTE: If the Write Protect function is turned on, "User Memory Write Protected" may be displayed. This is a safeguard to prevent you from writing over something you wish to keep. To continue the WRITE procedure, press UTILITY. To CANCEL the procedure, press EXIT.