Use the following procedure to load Tones on the S-50:

1. Insert the disk containing the desired Tone(s) and press P5.
2. Next to "DISK," enter the number of the Tone you wish to load.
3. Press +PAGE to display a list of the Tones currently loaded in the S-50's internal memory.
4. Next to "INT," enter the desired destination for the Tone you are loading.

NOTE: If you select a destination Tone that is not empty, the Wave data for the current Tone will be replaced by the Wave data for the Tone you are loading. Any Sub Tone that uses Wave data of the previous Tone will be deleted, becoming an empty Tone (see Section III for more information regarding Sub Tones).

5. Press SHIFT to open the command window.
6. Press ENTER to begin loading the Tone. "NOW LOADING" will be displayed on the Message Line. When the S-50 has finished loading the Tone, "COMPLETE" will be displayed on the Message Line.