The Omni Outputs on the back of the 01V can be used as Direct Outputs (Channels 1 - 16) as well as for Aux, Bus, and additional Stereo Outputs.

NOTE: If the Omni Outputs are used as Direct Outputs, they are Post-Fader.


1) Press the [PAN/ROUTING] button to locate the 'PAN/ROUTE' page '4'.

NOTE: The 'PAN/ROUTE' page number will be located on a tab in the upper left corner of the display.

2) Use the , , , or 'CURSOR' buttons to select the 'OMNI 1' parameter box in the 'OMNI OUT SELECT' section.

3) Turn the 'PARAMETER' wheel to select the desired source for the Omni Out.

NOTE: The sources listed are for Channels 1-16 (CH1-CH16), Aux (AUX1-AUX4), Bus (BUS1-BUS4), and Stereo (STOUT R, STOUT L ).

4) Press the [ENTER] button.

5) Repeat steps 2 - 4 for the remaining three Omni Outputs as desired.
Reference: Owners Manual, p. 116