1.Connect the MIDI IN connector of the CX-3 to the
MIDI OUT connector of the device that will transmit the data dump.
2.Set the Global channel of the MIDI device to match
the global MIDI channel of the CX-3 (set by the
Global mode Group 2 “MIDI Global Ch ” parameter).
If data that was previously transmitted to a MIDI
device is being re-transmitted back to the CX-3, set the
global MIDI channel of the CX-3 to the setting that
was used when transmitting the data.
For details on setting the MIDI channel for transmission,
refer to the owner’s manual of the device you are using.
3.Set the Global mode Group 4 “MIDI Rx Sys Exc ”
parameter to ENA.
4.Send the data dump from the transmitting device.
Refer to the owner’s manual for your device and
transmit the data.
If the “MIDI Rx Sys Exc” parameter is set to ENA,
data dumps can be received in either Normal mode
or EX mode.
5.When transmission is finished,the display will
indicate RxSysEx Completed.
If the display indicates RxSysEx Error, turn the power
off. Then while holding down the Program [2] and [7]
keys, turn the power on again. However, this will
initialize the contents of memory.
When the CX-3 receives data for one program, it will
enter the same mode (Normal mode or EX mode) in
which it was when that program was transmitted.
Since the CX-3 will switch to the received mode, you
will be in that mode when you press the [GLOBAL]
key or [EXIT] key to exit Global mode after receiving
the data dump.