I'm getting a two DSI error when booting the system, what can I do to get...

I'm getting a two DSI error when booting the system, what can I do to get around this?

You can use the Inhibit drive loading option in the ATTO ExpressPro -Tools control panel. This will eliminate the problem by reducing the number of drivers loading at boot.

Other Popular Articles:
• How long should my SCSI cables be?
• I am getting DAE -6042 errors (PCI too busy) in Pro Tools, what causes this error?
• What is the Inhibit driver loading option in ExpressPro-Tools, and when should I use it?
• Do I need to use an active terminator on the end of my SCSI chain?
• How should I configure wide and narrow devices on the ATTO SCSI bus?