After reinstalling the side panel on the Pro Control main unit the Pro...

After reinstalling the side panel on the Pro Control main unit the Pro Control will not start.

There are 2 lengths of screws used to attach the end caps to the Pro Control main unit. Use the shorter screw in the area closest to the rear of the unit, particularly on the side adjacent to the power supply switch. If the longer screw is used then the screw will end up touching the AC Input Line Filter lugs and shorting it out. This will prevent the ProControl from booting.

Other Popular Articles:
• "Not enough memory to draw overviews, could not open session because required resources were not found" error while reopening a session.
• Unexpected Authorization error 2108 Occurred. ID:ePAY:2108/KMgr:1031 DAE error = -7054, while launching PT NT with Plug-Ins installed.
• Unable to authorize plug-ins on Pro Tools NT. Floppy drive does not recognize the key disk.
• Can I convert a Pro Tools file to OMF? Why is "Convert Pro Tools to OMF" grayed out?
• DAE error -87 during playback or record.