Plasma meters are very jerky in Pro Tools. A new session with no plug-ins...

Plasma meters are very jerky in Pro Tools. A new session with no plug-ins does not exhibit this behavior.

Using automation on certain parameters on D-Verb plug-ins tends to make this happen. One specifically is the pre-delay parameter on D-Verb. There is no direct workaround other than not automating that particular parameter.

Other Popular Articles:
• Are Focusrite outboard gear products wired pin 2 "hot" or pin 3 "hot"?
• What do the terms " Zero degrees " and " 180 degrees " refer to in my Focusrite documentation, in regards to the pinout wiring?
• What are the rules for Track Transfer 2.11 concerning session bit depths, file formats, video track transfers and transfer destinations?
• 9073 "The PCI bus is too busy for DAE to communicate reliably with the audio hardware." DAE error message "-9073 - Disk too slow or too fragmented" During Bounce to disk.
• When you create a session from a template, is it normal for an Audio and Fades folder to be created in the template folder?