Drives not mounting on ATTO SCSI bus, or SCSI performance is unpredictable...

Drives not mounting on ATTO SCSI bus, or SCSI performance is unpredictable.

This can happen if you are running wide drives in a narrow enclosure connected to a wide ATTO card. You can use firmware ATTO firmware 1.63a1 or higher as a work around. Note: A configuration like this goes against SCSI spec and should not be used if at all possible.

Other Popular Articles:
• When reopening a session previously saved and closed with Reverb One, the plug-in comes up in default mode.
• Multi-Shell II and Pro Tools 5.1 DSP management.
• When bouncing to disk in Pro Tools 5.x, the time remaining countdown doesn't match the length of the audio selection.
• Unable to activate, deactivate, or access any insert or plug in after changing an insert's (plug-in or hardware insert) Active status.
• Can I use ATTO ExpressPro-Tools with SCSI drives connected to the Mac internal/external SCSI bus or with a non-ATTO SCSI accelerator (i.e. Adaptec)?