Clocking noise, clicks and pops with Pro Tools set to optical sync with...

Clocking noise, clicks and pops with Pro Tools set to optical sync with an ADAT bridge as master interface.

This has been seen with the Klotz Digital radio broadcast board sending lightpipe into the ADAT Bridge.Sending the ADAT Bridge AES sync works.Klotz has an ADAT card.

Other Popular Articles:
• Calibration Mode does not work properly in Pro Tools 5.1.
• Pro Tools 5.0.1 hangs with the tapping hand when trying to configure the Universal Slave Driver connected to the Mac serial port in the Setups > Peripherals dialogue. This can happen when it is trying to look for the port the Universal Slave Driver is connected to is the Mac serial port.
• Pro Tools 5.1 is losing I/O settings for tracks 17 and above.
• DAE error -11 when launching Pro Tools 5.1
• Pro Tools plays at an inconsistent speed or does not play at all when connected via Slave Clock BNC to a Mark of the Unicorn MIDI Timepiece AV (MTP AV).