 |
 |
 |
|
Q:
How do I change the operating level of the 888/24 from +4 to 10?
A:
The 888/24 I/O is factory set to +4 dBu operating levels for input and output. You can individually switch any of the analog inputs or outputs to either a +4 dBu or 10 dBu operating level by moving internal jumpers on its circuit board.This requires careful removal of the 888/24's top cover physically moving the jumpers corresponding to each input and output.Please refer to the 888/24 I/O Installation Guide for specific instructions and guidance.
Other Popular Articles:
• Why would I want to change the operating level of my 888|24? What's the difference? • How can I use the 888/24 in Stand Alone mode & how can I tell if it is in Stand Alone mode? • The default sample rate in Stand Alone mode is 44.1 kHz, how can I change that? • How do I enable/disable DAC muting when using Stand Alone mode? • Why are the inputs on my 888/24 distorting when connected to my Mix Farm card, but operate correctly when connected to another audio card? |
Copyright © 2026. All rights reserved.