Pro Audio Support

Q:
Surround panner link settings not being saved. When you use linking in a surround panner, close and then re-open a session the linking is turned off.
 
A:
This is a known issue and should be fixed in a later version.Workaround: manually reset the panner to the desired position.



Other Popular Articles:
• In pull down mode, does the sample rate of Pro Tools actually get pulled down if there is not a USD (or other clock device that supports pull down such as an MTP AV) connected as the clock master?
• Drives that have been hot-swapped are not recognized by Pro Tools or cause freezes.
• Using Kensington Mouseworks v5.6 on older pre-USB Macintoshes can cause crashes when choosing Finder while Pro Tools is launched.
• Audio is out of sync or dropped frames when playing back video at 1:1 or with multiple clients pulling the same video on Unity.
• Video plays back out of sync in Pro Tools 5.1.1 or earlier.