When recording or monitoring from the RCA analog out of the Audiomedia...

When recording or monitoring from the RCA analog out of the Audiomedia III Card, you can hear electrical pulses through the monitoring system each time the drive head accesses the drive.

Internal grounding problem with CPU and/or SCSI/ATA bus.Power, SCSI and Audio cables should not run parallel with one anther. Either isolate the cables from one another or have them cross at right angles to minimize/eliminate inductance between cables. The same goes for a wall plug that could have a unconnected ground pin. You can buy a $5 device that will tell you whether your wall socket is properly grounded or not.

Other Popular Articles:
• Does Pro Tools 5.1.3 support 23.98 fps (24 fps pull down)?
• Cannot perform the operation because a valid Time Compression/Expansion (TC/E) AudioSuite Plug-in is not installed
• How to record in from an Optical (2-channel) source into Pro Tools LE.
• In Remote Mode, is there a way to separate the track arming and sync so that for instance transport control is via LTC from one device and track arming is via 9 pin?
• Does Machine Control support more than 8 tracks of track arming in Remote Mode?