When my 1622 is functioning in stand-alone mode, signal routes through...

When my 1622 is functioning in stand-alone mode, signal routes through the box normally...but when I launch Pro Tools and try and route any of these signals into ANY session at ANY bit depth, there is no activity on the 1622.

This behavior can be caused by a bad Slave Clock BNC cable (the 1622 will not register "Slave" mode on its front panel if this is the case).Replacing the Slave Clock BNC cable will resolve this issue.

Other Popular Articles:
• When launching Pro Tools LE, I get "The current operation could not be completed because no write enable HD was found on the system".
• "The application Pro Tools 5.3 has unexpectedly quits because of an error type 3" on the launch of Pro Tools 5.3.
• What plug-ins run at192kHz sample rates?
• Error in Digi32.dll on WinME systems after installing Microsoft Office software.
• RTAS compatibility with Pro Tools|HD hardware and Pro Tools v5.3