How do I switch the SYNC I/O between NTSC and PAL?

Make sure that SYNC I/O is not in remote mode (the green remote light should be off). To take SYNC I/O out of remote mode hold down clock reference, positional reference, and frame rate. Hit the Set button on the unit's front panel, then use the up button to toggle through the menu until you see "Video Sy." Hit Set again and use Up or Down to select between NTSC or PAL. Hit Set to exit.

Other Popular Articles:
• SYNC Setup application doesn't have a choice for Digiserial port. How can I update the SYNC I/O's firmware or change other settings without this application?
• Release date for ADAT Bridge.
• Release date for Mbox.
• My iLOK dongle is not authorizing the plug-ins. When I try to use one of the plug-ins I get a message saying to find the copy protection then an error saying the hardware key cannot be found.
• -9129. Increase the hardware buffer error when adding new tracks to previously recorded material or recording more than X amount of tracks.