Although powered ON, my 3 SCSI hard drives do not mount when the computer...

Although powered ON, my 3 SCSI hard drives do not mount when the computer boots. However, I can mount them with ATTO EPT or Drive Setup. If I run Drive Setup, I don't have access to the drive's properties and it says 'this disk has at least one write protected volume'.

Despite reseating cables, termination and swapping the drives to a different SCSI bus, formatting the drives is what ultimately solved the problem

Other Popular Articles:
• What type of screw threads does Pro Control's DB-25 connectors use?
• Can I run Logic Audio with Mbox?
• Values entered into the sample-offset fields of MIDI tracks in the MIDI Offsets Window do not register as expected; negative values subtract from the previously entered values.
• "Pro Tools hardware is either not installed or used by another program" error when launching Pro Tools LE
• Is it possible to reset a DigiDrive to its factory (Mode Page) settings after it has already been optimized with DigiDrive Tuner?