 |
 |
 |
|
Q:
In the Control 24 manual it states that the Auxiliary Inputs on the Control|24 are routed in the Control Room Monitor section. Is this the case? If so, how do I route the Aux In on the C|24?
A:
The manual is incorrect. The Auxiliary Inputs, left and right, get automatically routed to the Aux Out. note: If "Monitor to Aux" is selected then the automatic patch from Aux In to Aux Out is broken until "Monitor to Aux" is deselected.
Other Popular Articles:
• How to Check your system for any resource (IRQ) conflicts on Win98 SE and WinME. • How do I Enable DMA for all IDE/ATA drives in on Win98 SE and WinME? • Disable all Startup Items from the system to prevent conflicts when using Pro Tools LE software on Win98 SE and WinME • Sync IO will not generate time code while Pro Tools is in remote transport mode. • In general is there anything I should know about driver errors? |
Copyright © 2026. All rights reserved.