 |
 |
 |
|
Q:
When I engage the global control of PRE on my Pro Control or Control|24, I don't see all 8 channels.
A:
When switching to remote control of PRE, only the corresponding Pro Tools channels with PRE channels assigned will display the controls. For Example, if PRE channels are assigned to the ODD numbered channels within Pro Tools, the controls will be displayed on ODD numbered channels on a Control|24.
Other Popular Articles:
• When launching a session I get a DAE error -9204. • If you move a session to a new directory (on the same drive or a different disk) that had been converted from an OMF file, Pro Tools recalculates the waveforms again. • What voltage should a 0 VU 1 KHz tone produce on the properly calibrated output from an analog console? • An assertion occurred in "Sys_FileType.cpp", line 74 (or line 57) • Error -37 when performing a Save Session Copy In |
Copyright © 2026. All rights reserved.