When MachineControl issues a stop command, the deck "fumbles" around due...

When MachineControl issues a stop command, the deck "fumbles" around due to a small (approximately 1 frame) selection that is created on the timeline.

This is a known issues in Pro Tools 5.1.1 and higher. It will only happen when using LTC for positional reference with Transport = Machine and Pro Tools set to online. It does not happen when using Serial Timecode. It also only occurs when "Timeline Insertion Follows Playback" and "Machine Follows Edit Insertion/Scrub" are checked in preferences. The selection is created between the initial stop command and when the machine stops reading time code.

Other Popular Articles:
• DAE Error -2804 upon launching Pro Tools TDM for HD.
• What is the best way to convert a 24-bit, 48kHz session to a stereo file for an Audio CD? (Bounce To Disk)
• AVoption|XL functions are disabled when launching Pro Tools 5.1.3 or earlier with AVoption XL.Avid System Test Pro reports "Digital Media Board has failed to initialize properly" at launch.
• PRE manual states that the PRE is "pin 1" hot. Is this correct?
• My audio is out of sync with the movie when I Bounce to Movie when using Pro Tools 5.3.2 on windows XP.