1 Select the restore destination drive.
Use the [SONG] “SelSong” tab page or the [SYSTEM]
“DiskUtil” tab select the restore destination
drive.
2 Select the Restore operation.
In the [SYSTEM] “B–U/Rst” tab page, set “B–U/
RstType” to “Restore.”
3 Insert the disk into the restore source drive.
4 Select the restore source drive (“Source”).
Press the “Drive” button to access the dialog box.
Select the drive, press the “OK” button.
5 Select the backup source song (“Source”).
In the case of a disk that was backed up using
“BackupAllSongs,” you can select whether to
restore all songs or just a single song. Use “Source”
to select the song that you wish to restore. To
restore all songs, choose “SelectAll” in the dialog
box.
6 If you are restoring a single song, select the
restore destination song (“Destination”).
7 Execute the restore operation.
Press the “Exec.” button. In response to the “AreYouSure?”
confirmation, press the “Yes” button to
execute the operation.
If you are restoring from a backup that extended
across multiple disks, you will be asked for the
next disk when the data has been restored from the
current disk. Insert the next disk, press the “OK”
button.
8 Specify whether the effect user data will be
restored.
After the song data has been restored, the
“RestoreUserData” message will appear, asking
you whether the current user data should be overwritten
by the user data that was saved at the time
of the backup. If you wish to overwrite the current
data, press the “Yes” button. If not, press the “No”
button.
If the current data is overwritten, it will be lost.
9 When the operation is completed, the display will
indicate “Completed.” Press the “OK” button.
Destination Source0