Pro Control on NT is not recognized

Pro Control on NT is not recognized.

With Pro Tools installation all the required files are installed
Follow the directions below to make Pro Control work with Pro Tools.
install the diginet driver as follows:
* goto the network control panel protocols tab>Add>Have Disk.

* type the full pathname for the ProControl directory e.g. C:\Program Files\Digidesign\DAE\Controllers\ProControl and it should find NDIS 3.0 packet driver v3.5.

* Select OK, close and restart.

Other Popular Articles:
• "Please increase H/W buffer size" message during playback, bounce, etc.... When increased to 1024 samples get "Please decrease H/W buffer size" message. Occurs in Pro Tools LE for Windows 98SE.
• Is there any way to increase the Apple Desktop Bus (ADB) cable greater than the maximum length of 5 meters to 100 feet?
• Pro Tools does not support NTSC video playback with the Aurora Fuse card. Frame stutters occur when playing back NTSC video and using multiple stereo sends. Refer to the Digidesign web site for driver updates.
• Should "do not map through this device" be checked or not? Why is this included in the wavedriver?
• How do I load a single bank of Combis or Programs?