No audio from 888 I/O outputs, even though there is activity on the meters...

No audio from 888 I/O outputs, even though there is activity on the meters.

- System not powered up correctly. Turn on the 888 and the hard drives, then boot the Mac. This allows the Digi INIT to initialize the 888.- Wrong Peripheral selected in Hardware setup window. Select 888 I/O.- Incompatible version of DAE (use the DAE that came with Pro Tools).- TDM Ribbon cable not seated properly or is damaged.- Verify that the Mode switch on the back of the 888 is set to 8 CH Mode (button should be in).- Verify the 50-pin cable is connected to the Computer 1 port on the 888 (some older 888's have a Computer 2 port).- Check the ends of the 50-pin cable for bent or broken pins.- One user reported that skipping a TDM node between cards resolved this.

Other Popular Articles:
• No audio playback on a PTIII-PCI system, even though there is meter activity on the Audio Interface.
• No audio playback (or poor audio quality, noise) from outputs 5 through 8 on an 888 I/O.
• No card available or "You need a Digi DSP card" when launching Sound Designer II with Logic Audio already open.
• "No response from ADAT" error appears when choosing ADAT I/O in the peripherals menu
• No volume knob is displayed on a track.