"Pro Tools hardware is not turned on", DAE -9045, or noise from all outputs...

"Pro Tools hardware is not turned on", DAE -9045, or noise from all outputs when Pro Tools is slaved to an external signal set to 48k. Setting the external sync signal to 44.1 solves this problem.

This can occur when long BNC cables are used to slave the 2 Audio Interfaces. Switching to shorter BNC sync cables (shorter than 6 Ft.) can solve this.

Other Popular Articles:
• When dragging a region out in Spot Mode the message "Timecode is not available" will appear, or when clicking on a region in a track while in Spot Mode the message "Timecode exceeds Session" will appear.
• Pro Tools has to calculate the overviews for a session every time that session is opened.
• Jerky movie playback (~3 fps) in Pro Tools on a VideoVision card when movie is blown up (pixel doubled) to full screen. Movie plays fine in the small (320x240) screen.
• Release dates and versions for D-fx (Chorus, D-Verb, Flanger, Multi-Tap Delay, Ping-Pong Delay).
• MicroLynx is not recieving timecode from Pro Tools.