Q:
Digi 002 stays in standby mode after update to system firmware 0.38.
A:
1) Quit Pro Tools2) Turn the Digi 002 on and off
Other Popular Articles:
• I/O setup problems with a Digi 002 and Pro Tools LE 5.3.2 when Opening a TDM session, and choosing "default" for Input pane. This results in the S/PDIF channels being assigned to channels 7-8, when they should be assigned to channels 17-18.• After downloading the latest firmware, and opening a session for the first time after the download, I get the following error:Pro Tools was not able to reacquire the hardware and must now exit. Message ID=-1115Read me: Without restarting the computer, if I start Pro Tools a second time, and try to open the same session, everything seems fine. It's hard to say how often this could happen since firmware downloads don't happen to often.• Pro Control Main Audio pot on the Control Room panel produces unequal stereo imaging or a difference between the Left / Right audio channels.• When D-Verb is instantiated, it outputs an oscillating, pulsing, or other type of noise, even if there is no audio passing through the plug-in.• How can I test the MIDI ports on my 002?
|
|
