 |
 |
 |
|
Q:
Can't get Pro Tools to slave to Motion Worker controller with SSL via MachineControl in Remote Mode.
A:
When using any controller for Remote Mode, you must use the female 9-pin to serial cable designed specifically for remote mode. Make sure that Pro Tools is online and that transport = remote
Other Popular Articles:
• What settings must be made on the Motion Worker controller when using it to control Pro Tools in Remote Mode with MachineControl? • "Not enough memory available to run DAE" or "Pro Tools requires XXXXXk, but there is only 0k available" at Pro Tools launch. • What is the longest Firewire cable that can be used with the Digi 002? • The faders on the Digi 002 stay stuck at Infinity (all the way down) in Stand Alone Mode and when Pro Tools is launched. However, Pro Tools is able to control the faders on Digi 002, but not the other way around. Digi 002 already has fader firmware update v.105a. • Why does opening the Import Audio dialog take so long in Pro Tools 5.x? |
Copyright © 2026. All rights reserved.