Use “Drive select” to select the drive, and make sure that
If the CDRW-1 option is installed, or if a CD-R/RW drive is
connected as an external SCSI device, you can play back
audio CD’s in Disk mode.
If you are using a SCSI-connected CD-ROM/R/RW drive,
connect the audio outputs of the drive to the AUDIO INPUT
1 and 2 of the TRITON STUDIO.
It is convenient to use this method to verify a CD that you
created in the Make Audio CD page.
The audio CD will play back according to the Analog setting
for “Input (COMBI, PROG, SEQ, S.PLAY, DISK).”
It is not possible to play back an audio CD that has not
been finalized.

The audio CD can be controlled by the SEQUENCER keys.
If the CDRW-1 option is installed, playing the TRITON
STUDIO’s keyboard or operating the controllers during
CD playback may produce physical shock that causes
the data to skip or read errors to occur, preventing play-back
from occurring normally. Please use caution.
SEQUENCER[START/STOP] key : Play/Stop
[FF>>] key : Fast-forward
[<[PAUSE] key : Pause
[LOCATE] key : Return to the beginning
of the track


Since some CD-R/RW drives do not support this, the
volume may not change when you adjust this setting.
0–5b: Input
Input [Analog, S/P DIF, mLAN]
Input1:
Input2:
Level [0...127]
Pan [L000...C064...R127]
BUS (IFX/Indiv.) Select
[L/R, IFX1...5,1, 2, 3, 4, 1/2, 3/4, Off]
Send1 (MFX1), Send2 (MFX2) [000...127]
Here you can specify the input source, input level, pan, bus,
and master effect send for analog/digital audio devices.
Input settings are valid in Combination, Program,
Sequencer, Song Play, and Disk modes. (•••Global P0: 0–
3a)
Normally you will set these parameters as follows.
Input1 (L channel):
“Level” 127, “Pan” L000, “BUS (IFX/Indiv.) Select” L/R,
“Send1”/“Send2” 000
Input2 (R channel):
“Level” 127, “Pan” R127, “BUS (IFX/Indiv.) Select” L/R,
“Send1”/“Send2” 000
This displays information on the media that is selected by
“Drive Select” (0–1c).