What firmware version should I be running with D-Control?

The original shipping firmware version was 3.0.2. which is for use with Pro Tools 6.4. At the time of this writing, Digidesign is including Pro Tools 6.4cs1 with all D-Control units (located in the D-Control product registration envelope) which should be installed during initial setup. When first configuring D-Control in Pro Tools 6.4cs1, the software will request that the firmware be updated. The resulting firmware version will be 3.1.0. To display the D-Control firmware version:
1) Press the Utility button on the D-Control.
2) In the Soft Keys Section, press "System," then "FW Ver."

Other Popular Articles:
• My mixer is the digital Yamaha O1V. As you probably know, this type of board doesn't have insert channels. So I'm wondering if I can send my mics straight into the ACP88, use the compression/gate/limiter functions and THEN go into the board. In other words, does the ACP88 function properly if it is used before the mic preamp?
• What is the feature/sonic difference (improvement) from the ACP8 to the ACP88?
• I purchased an ACP88 and the only thing that is not clear to me is the +4/-10dBu button on the back. What is the difference between "pro levels" and "line levels"?
• Can I use ASIO drivers with my Event EZBus in Windows? My software application is not recognizing the ASIO driver.
• How do I know if my EZbus is properly installed in WinXP / WinME?