Pro Audio Support

Q:
Does AppleTalk need to be on for ProControl communication?
 
A:
The AppleTalk Protocol does not need to be turned on (in the Chooser). However, the AppleTalk control panel needs to be set to Ethernet.



Other Popular Articles:
• Can MIDI Controller parameters be controlled from a ProControl?
• Can the armrest be replaced in the field if it is chipping or peeling?
• Where is the firmware located for the ProControl? Do I need to rev the unit's firmware?
• There is a 6db drop on the Main L/R outputs while in surround monitor mode. When switching the ProControl to stereo monitor mode the level goes back up to +4 (unity) The level on the Surround L/R and center/lfe channels stay at unity in both surround and stereo monitor modes. All of the pots are up on full. Is this the correct behavior?
• Why do I get feedback when using talkback in surround mode?